Hi Madhu,
Your connector name created in SM59 and Logical Port name maintained in BD54 should be the same - Its same
Also in the path Maintain Connectors and Connection Types - Its Done
Add your connector as
Target Connector( Your SM59 connector) - Done
Connection Type (SAP) - Done
Logical Port (Same as in your BD54, of course your connector will be also with the same name) - Done
Then Create Connector Group - Any name as per your naming convention - Done
Assign Connector group to Group Type - Logical Group - Done
Now add your Connector to Connector Group created. Then complete all below steps - Done
Maintain Connection Settings - Done
Maintain Connector Settings - Done
Maintain Mapping for Actions and Connector Groups - Done
IMG parameters Config - Done
Make sure your Ruleset is already loaded in system and make sure that logical systems in the rule set match the logical systems that you connectors are mapped to - In which tables or configuration should i check this?
Then run all the sync jobs for the connector which is created above and mapped to your connector group - Done