Re: IDOC Control record for partner Type KU

There are multiple way to achieve this requirement where you need to send a Customer KU as the Sender Partner type when sending the IDoc.

1. Map SNDPRN and SNDPRT to KU and corresponding partner number respectively in the EDI_DC40 and select option -> Take Sender from Payload in the Idoc Adapter.
2. Create a Receiver Party and assign below values. In receiver agreement perform Header mapping and select this Receiver Party for Header Mapping.
   • AGENCY = Receiver SAP Sytem Logicial System
   • Scheme = ALE#KU
   • Name = <PartnerNumber>
3. Assign the Receiver Party and Service as created in Receiver Determination

I would recommend Option 1 as the easiest and simplest but do make sure that the Partner number is same in both QA and Production. If the Partner number value will change,. you would need to make sure you make this configurable through Parametrized Mappings or Value Mapping..

Regards

Bhavesh