Re: Repair on a BOM item?

ASHISH

----------------------------------------------------------------------------------------------------------

• If your interest is to track Movements then make it an Equipment (a Sub equipment under your Motor).
  • Then have few functional locations such as
    • Defective
    • Under Repairs
    • Ready
  • When the Bearing needs repairs it will be Dismantled from the structure and installed in Defective FLocn.
  • When it is sent for repairs it will be dismantled from defectice and installed in Under Repairs FLocn
  • Similarly after repairs and before fitting into Motor it will be under Ready FLocn
  • This gives complete track of the Bearing through Usage Period (I hope you know)

--------------------------------------------------------------------------------------------------------------------

• When you use word Inventory, it sounds some Value to the Material. In that case Refurbishment is the only answer.

-------------------------------------------------------------------------------------------------------------------

• If it is about Quantity tracking only (as a Material), but not then the value then, you can take advise from MM people about
  • What type of Material it should be created (like non-valuated)
  • And what types of MvtTyps can be used for performing the tracking of the Material equivalent to stages we discussed above in Equipment usage period .

--------------------------------------------------------------------------------------------------------------------

I believe the first case will be better and on the Equipment you can Create and Process Orders capturing all costs.

Regards

KJogeswaraRao